保定市清苑区模板加工厂

为了能够注塑成型生产出装饰性较好的零件，除了延长模具的使用寿命之外，制造商还希望铝制模具的表面能够保持一定程度的光泽度，因此建议采用非电镀的镍喷涂工艺，因为这种方法有助于延长模具表面光洁度的寿命，使其生产装饰性零件相对比较容易。

In order to be able to produce good decorative parts injection molding, in addition to extend the service life of mould, manufacturers also hopes to maintain a certain degree of aluminum mold surface gloss, so suggest adopting the electroplating nickel coating process, because this approach helps to prolong the service life of the mold surface finish, make its produce decorative parts is relatively easy.

由于铝材的质地较软，如果不采用表面涂层，就容易被塑料磨损，加速其损坏程度，从而改变注塑成型件的光泽度。非电镀镍涂层可使模具表面增加50RC，使其足以保护和延长模具表面的光泽度和结构。非电镀镍涂层可以比铝材本身获得更好的表面光洁度质量，但必须指出的是，在模具可以电镀前，首先需要进行一些表面处理。例如，为了使其能够达到透镜级的质量水平，建议首先将铝制模具的表面加工到SPIA-3级光洁度水平，然后在其进一步抛光前，再应用0.0003~0.0005的高磷非电镀镍涂层，使其达到钻石级质量的光洁度水平。

Due to the quality of a material of aluminous material softer, if you don't use surface coatings, is easy to wear plastic, accelerate its damage degree, and transform the glossiness of the injection molding von berg systeme. Non-electroplated nickel coating can increase the surface of the mould by 50RC, which is sufficient to protect and extend the gloss and structure of the molds. Of electroplating nickel coating can get a better surface finish quality of aluminous material itself, but it must be noted that, in the mold can be before electroplating, first of all need to do some surface treatment. For example, in order to enable it to reach grade lens quality level, Suggestions to the surface of the aluminum mold processing to SPIA first - level 3 finish level, then before the further polishing, and the application of 0.0003 ~ 0.0005 high phosphorus plating nickel coating, to the diamond level of finish quality level.